Sonata Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
New member here....
Have a 2007 Sonata (2.4 L inline 4) and been plagued with rough/shaking car when initially started and pull to stop, and generally goes away when fully warmed up. Recently had oil change and service area switched me to a lower viscosity oil (5W30 to 5W20) and checked a solenoid and it was fine. Also did a fuel service treatment I suppose in an attempt to flush out stuff........I was a little surprised he didn't pursue talking about tuneing up aspects but maybe none of those codes flashed......a repeating code I do have is Code 11.........though I confess when the codes refer to emission stuff I sort of ignore them.......any thoughts welcome.
pete
 

·
Registered
Joined
·
1 Posts
When you say you checked the solenoid, do you mean to the charcoal evap canister? I think that's what it is called. a valve opens/shuts to allow proper oxygen mixture, when it malfunctions your car may have hard starts due to irregular ratio's of o2 & gas.
 

·
Registered
Joined
·
10 Posts
A P0011 DTC trouble code may be caused by one or more of the following:
  • Incorrect camshaft timing Wiring problems (harness/wiring) in intake timing control valve control solenoid system Continuous oil flow to VCT piston chamber
  • Failed timing valve control solenoid (stuck open)
So they check the soleniod how about the wiring. Even if the soleniod is not sticking the electricial side of it could be out for its limits.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top